Router Table Features Laminated Cabinet Functionality.

Users simply position the tall aluminum 4-7/8 by 25-1/8-inch fence, with adjustable MDF face plates into place. For convenient bit height adjustment capability, Bosch recommends using a router and base with a through-the-table adjustment feature, such as the Bosch 1617-series routers and the Bosch RA1165 Router Table Base (sold separately). Additionally, a dual outlet switch and a 6-foot cord eliminate the need to reach under the table after initial set up.
For the original version including any supplementary images or video, visit

Route Summarization


CABINET LEVELING SYSTEM : MorningStar Innovations & Design Inc. Feb. 4-6: Kitchen & Bath Industry Show , Las Vegas, NV Feb. 11-14: FIMMA-Maderalia , Valencia, Spain Feb. 16-20: EuroShop . DUsseldorf, Germany April 16-19: NWFA Wood Flooring Expo , Nashville, TN April 28-May 2: Woodworking Industry Conference , Rio Grande, Puerto Rico May 12-14: RadTech UB/EB Technology & Conference , Rosemont, IL May 13-17: Xylexpo , Milan, Italy May 28-31: NAPO’s Annual Conference & Organizing Exposition , Phoenix, AZ June 9-11: NeoCon , Chicago, IL About the Author Rich Christianson Rich Christianson is Associate Publisher and Editor at Large of Woodworking Network.
For the original version including any supplementary images or video, visit

Using the Dremel Shaper/Router Table and Conclusion

Dremel Shaper / Router Table Review Using the Dremel Shaper/Router Table and Conclusion

Click to enlarge As well as cut depth, youre able to adjust the angle of the guide bar and protective shield to your requirements, depending on the finish youre trying to achieve or the depth of material youre dealing with. The main limitation of the table is its size, which will limit the length of materials you can easily pass by/over the cutting/sanding bit. Click to enlarge Using sanding bands proved to be a doddle and we were able to achieve smooth curves on the corners of acrylic sheet much easier than with a rotary tool alone or with the Dremel Workstation. With soft materials, it was quick and easy to shave off a specific amount off one edge, while routing bits were able to deal with harder materials. Leaving the rotary tool and cutting bit to do most of the work, we didnt see any signs of flaws in the cuts due to tool movement; so long as you dont apply too much pressure, the Router / Shaper is able to provide clean, accurate cuts. Conclusion In reality, calibrating the Dremel Router / Shaper proved to be a bit of a pain, but its likely youll only have to do this once each time you come to do some routing. For sanding and shaping, it provides both a sturdy mount for your rotary tool, and an effective means of using sanding bands as well as a modest-sized worktable for these tasks.
For the original version including any supplementary images or video, visit

Router Kits, Table Legs & Wallbeds Among 2013’s Top Products

WWN Products

If we were not summarizing, those flapping messages would propagate through the entire corporate system, putting a totally unnecessary and performance-robbing load on the routers. Once you summarize, the summary is stable: It cant flap because it is not a real network. Its just like a spokesperson at a press conference: The rumors of a fire at the Springfield plant have had no impact on production whatsoever. Meanwhile, the Springfield plant could be a charred hulk. The summary is still valid, and traffic will still be sent to the router connected to the flapping network. This keeps people from asking any more questions about the Springfield fire. However, if someone were to send a shipment to Springfield, it would be hastily redirected to another site (or dropped). All we have done is hide the problem from the rest of the world so that we dont flood the Internet with rapid-fire routing updates.
For the original version including any supplementary images or video, visit